IMS Verify

A number on the screen
is not the whole story.

Compare what the controls command with available measurements and observed machine behavior. Give your team a documented basis for the next decision.

Coating · Laminating · Slitting · Rewinding · Web handling

Send Nick the Problem

Make the evidence useful

Commanded. Measured. Observed.

Commanded

What the PLC, HMI, drive or recipe asks the machine to do.

Measured

What suitable instruments or validated methods can establish, with the method and limits recorded.

Observed

How the machine, web and finished roll behave under the tested conditions.

A focused test plan

Check the behavior that matters.

Tension & speed

Selected tension zones, section speed relationships and variation through acceleration, running and slowdown.

Winding & loading

Torque-related behavior, diameter, taper, pressure and machine response, using appropriate available evidence.

Before & after a change

A baseline or a focused recheck after tuning, a controls change, component replacement or rebuild.

Drive torque estimates are identified as estimates. Pressure is not labeled as directly measured nip force. Independent instruments are used where feasible; machine-reported data and calculations remain clearly identified.

What was checked.
What was found.
What comes next.

An agreed test plan, recorded conditions and methods, a clear result and a practical next step. Separate verified results from observations, open issues and items not tested.

Performance verification, not blanket certification. IMS Verify does not certify machine safety or regulatory compliance. Conclusions apply to the tested conditions. When IMS also makes the corrections, that role is stated; the work is not described as independent third-party certification.

Bring us the problem

What do you need to know about the line?

An uncertain reading, recurring defect or planned upgrade can be the starting point for a focused check.